I assume you’re working with a Sunrocket SPA2102-R.

>when booting from the software disc, the directions clearly state that ethernet cable should be connected to the **INTERNET** port…

I think you are right about the ports. I’ll correct that in the tutorial. Thanks for bringing that to my attention.

>Other than that, when pressing **** –> “723646#” , the password “79309925#” is not accepted….

Did you stop there or did you continue with the process? If I remember correctly, I got the same message, but I disregarded it and continued the process anyway, and it worked.

Let me know if that helps.

I’m sorry – but you’re article’s instructions contradict the software’s instructions.

For example, you say that the ethernet cable should be connected to the yellow ethernet port on the ATA device – but when booting from the software disc, the directions clearly state that ethernet cable should be connected to the **INTERNET** port…

Other than that, when pressing **** –> “723646#” , the password “79309925#” is not accepted….

I don’t know – perhaps I’m doing something wrong.. but this doesn’t work for me. Any ideas?